The APT Model M133CN D Handle Rivet Buster or a Jumbo Rivet Buster as it is known, was originally designed to cut rivets off metal structures. This model is widely known as a tough, powerful tool, with the ability to perform medium to heavy-duty demolition work. At half the weight of the 60 lb class paving breakers, the ratio of its high-impact energy versus its weight makes the Rivet Buster series the most efficient tool produced by APT. The Model 133 meets the weight requirements for bridge deck repair work. Rivet Busters are also popular for cutting up underground tanks.
| Model - Part #: | Units | M133CD D - 18768 |
| Bore Diameter | in | 1 - 3/16" |
| Stroke | in | 8" |
| BPM | bpm | 1,140 |
| CFM @ 90 psi | CFM | 42 - 46 |
| Weight | lbs | 30 |
| Length | in | 22-1/2 |
| Air Inlet NPT | in | 1/2" Female NPT |
The recommended air requirement for the operation of APT tools is 90 psi (6.2 bar). Lower air pressure will decrease power, too high a pressure will increase unwanted stresses in the tool. For proper CFM ratings, please refer to the specification charts shown for each tool in this catalog.
APT recommends the use of at least 1⁄2” inside diameter or larger hoses to assure sufficient air flow to the tool. For portable compressor hose and longer lengths, 3⁄4 “ hose is recommended. Keep the overall length of the hose to a minimum to prevent pressure loss at the tool.
Hoses should be rated for a minimum of 250 psi (17.2 bar). Before connecting the air hose to the tool, check the tool inlet connector to be sure it is clean and free of dirt or debris. Keeping dirt and debris from entering the tool will assure long and satisfactory operation.