The APT Model M1133CN D Handle Rivet Buster is a Jumbo Rivet Buster with an 11" stroke. This model complements the "classic" 133 Rivet Buster in those applications where heavy demolition force is required. The tool is widely known as being tough and powerful, with the ability to perform heavy demolition work. Rivet Busters are also popular for cutting up underground tanks.

TECHNICAL INFORMATION

Model - Part #: Units M1133CD D - 18846
Bore Diameter in  1 - 3/16"
Stroke  in  11"
BPM  bpm 850
CFM @ 90 psistar w/neutral)  CFM  48 - 52
Weightstar w/neutral)  lbs  33
Lengthstar w/neutral)  in  25-1/2
Air Inlet NPTstar w/neutral)  in 1/2" Female NPT

STANDARD FEATURES

  • 11" Stroke
  • Drop forced, D-style steel handle
  • Uses Jumbo extra heavy duty tool steel
  • Inside trigger for better control and safety
  • Deep case-hardened allow steel cylinder
  • Heavy duty upper and lower sleeves
  • Adjustable exhaust deflector
  • Teflon throttle valve

Air Pressure

The recommended air requirement for the operation of APT tools is 90 psi (6.2 bar). Lower air pressure will decrease power, too high a pressure will increase unwanted stresses in the tool. For proper CFM ratings, please refer to the specification charts shown for each tool in this catalog.

Hose Size

APT recommends the use of at least 1⁄2” inside diameter or larger hoses to assure sufficient air flow to the tool. For portable compressor hose and longer lengths, 3⁄4 “ hose is recommended. Keep the overall length of the hose to a minimum to prevent pressure loss at the tool.

Connecting Hoses

Hoses should be rated for a minimum of 250 psi (17.2 bar). Before connecting the air hose to the tool, check the tool inlet connector to be sure it is clean and free of dirt or debris. Keeping dirt and debris from entering the tool will assure long and satisfactory operation.